User's Manual

Table Of Contents

Figure 5-18 Fitting the metal shell onto the twisted-pair cable

Step 4 Fit the metal shell onto the twisted-pair cable until the shield layer is covered completely. Along

the edge of the metal shell, cut off the aluminum foil shield layer and ensure that there is no

surplus copper wire. The exposed twisted-pair cable is about 20 mm (0.79 in.) long, as shown

in Figure 5-19.

Figure 5-19 Removing the shield layer of a twisted-pair cable (unit: mm (in.))

Step 5 Lead the four pairs of twisted-pair wires through the wire holder, as shown in Figure 5-20 and

Figure 5-21. Ensure that the colored wires are in the correct location in the cable.

Figure 5-20 Leading wires through the wire holder

AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 12 (2015-08-05) Huawei Proprietary and Confidential