User's Manual

Table Of Contents

Step 3 Check whether the contact strips are clean. If they are not clean and the dirt cannot be removed,

replace it with a new RJ45 connector. Figure 5-35 shows an unqualified piece.

Figure 5-35 Dirt on a contract strip

Step 4 Check whether the contact strips and the plastic separators are well aligned and intact. If a

separator is skewed and cannot be fixed, replace it with a new RJ45 connector. Figure 5-36

shows an unqualified piece.

Figure 5-36 Skewed plastic separators

Step 5 Hold the connector with the side facing towards you, and check whether you can see the cross-

sections of the wires. Ensure that the ends of the wires are in good contact with the edge of the

RJ45, and that the contact strip blade extends beyond the ends of the wires and is crimped with

the wires. If not, replace the connector. Figure 5-37 shows an unqualified piece.

Figure 5-37 Wires not in good contact with the edge of the RJ45

AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 12 (2015-08-05) Huawei Proprietary and Confidential