User's Manual

Table Of Contents

NOTICE

If the two terminals are different sizes, place the smaller one above the bigger one. A

maximum of two terminals can be installed on a post.

l To remove an OT terminal, loosen the screw counterclockwise.

----End

Installing the Cord End Terminal

Procedure

Step 1 Hold a cord end terminal upright and place it on a terminal jack, as shown in Figure 5-48. To

ensure bump contact and dense connection, place the plain side of the terminal outwards.

Figure 5-48 Placing a terminal on a terminal jack vertically

Step 2 Insert the terminal into the jack vertically, and turn the screw clockwise to fasten the terminal,

as shown in Figure 5-49.

Figure 5-49 Feeding the terminal into the jack

AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 12 (2015-08-05) Huawei Proprietary and Confidential