User's Manual

Table Of Contents

NOTICE

l Ensure that the exposed section of the terminal is less than 2 mm (0.079 in.) in length.

l Do not press the insulation of the terminal.

l Insert only one terminal into one jack.

Step 3 Move the cable slightly and ensure that it is securely connected.

Step 4 Before you remove a cord end terminal, loosen the screw counterclockwise.

----End

Installing Ethernet Adapters

Installing a Shielded Ethernet Connector

Procedure

Step 1 Hold the male and female connectors, with the male connector facing the female connector, as

shown in Figure 5-50.

Figure 5-50 Holding the male and female shielded connectors

Step 2 Insert the male connector into the female connector, as shown in Figure 5-51.

AP3x10xN&5x10xN&5x30xN&6x10xN&7x10xN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 12 (2015-08-05) Huawei Proprietary and Confidential