User's Manual

Table Of Contents

Requirements for Feeding the Printer

The label paper consists of two layers. No matter what model of printer you use, feed in the

labels one page at a time. To avoid jamming the labels, never use the auto-feed mode.

Requirements for the Printed Label

Make sure that the printed labels satisfy the following requirements:

l All the printouts must be on the label, and nothing should be printed on the backing layer

of the label page.

l Contents

in the cells should be aligned in the center. In a single-line printout, the dividing

lines and the mark "To:" should not be covered by the printed characters.

l When the cells are merged and the printouts are made in multiple lines, avoid covering the

mark "TO:" when printing the texts. Use the space bar to move the text to the next line.

Writing Labels

Writing Tools

To make sure the printouts are clear and legible, use the black markers instead of ball-point pens

to write the labels.

In special cases, black ball-pens are allowed, although not recommended. Compared with ball-

point pens, water-proof markers are better. When writing with a ball-point pen, do not leave the

oil on the label, which may contaminate the label and blur the words.

NOTE

The delivered marker has two nibs. Make sure to use the smaller nib to write the labels.

Font

For

the sake of easy recognition and good appearance, the font in handwriting should be as close

to a standard typeface (such as Times New Roman) as possible. Table 5-21 shows the standard

typeface.

Table 5-21 Standard typeface for handwriting

1 2 3 4 5 6 7 8

9 A B C D E F G H

I J K L M N O P Q

R S T U V W X Y Z

The characters should be clear, distinct, and tidy.

Writing direction: The direction is shown in Figure 5-84:

Huawei Indoor Access Points

Hardware Installation and Maintenance Guide 5 Appendix

Issue 08 (2014-04-10) Huawei Proprietary and Confidential