User's Manual

NOTE
l Indicator colors may vary slightly at different temperature.
l After
a Fit AP is powered on, you can run the led off command on the AC to turn off all AP indicators.
To restore the indicators to normal working status, run the led on command. Indicators on a Fat AP
cannot be turned off using the led off command.
Single indicator and SYS indicator
Table 1-3 Descriptions about the single indicator and SYS indicator
Type Color Status Description
Default
status after
power-on
Green Steady on The AP is just powered on and the software is not
started yet.
Software
startup
status
Green Steady on
after
blinking
once
After the system is reset and starts uploading the
software, the indicator blinks green once. Until the
software is uploaded and started, the indicator
remains steady green.
Running
status
Green Blinking
once every
2s
(0.5 Hz)
l The system is running properly, the Ethernet
connection is normal, and STAs are associated
with the AP.
l The system enters the Uboot CLI.
Blinking
once every
5s
(0.2 Hz)
The system is running properly, the Ethernet
connection
is normal, and no STA is associated with
the AP. The system is in low power consumption
state.
Alarm Green Blinking
once every
0.25s (4
Hz)
l The software is being upgraded.
l After
the software is uploaded and started, the AP
working in Fit AP mode requests to go online on
the AC and maintains this state until it goes
online successfully on the AC (before the
CAPWAP link is established).
l The AP working in Fit AP mode fails to go online
on the AC (the CAPWAP link disconnects).
Fault Red Steady on A fault that affects services has occurred, such as a
DRAM
detection failure or system software loading
failure. The fault cannot be automatically rectified
and must be rectified manually.
Huawei Indoor Access Points
Hardware Installation and Maintenance Guide 1 Indoor AP Overview
Issue 08 (2014-04-10) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5