User's Manual

Table Of Contents

Figure 3-2 Selecting the connected port

4. Set communication parameters, click Restore Defaults, and then click OK. See Figure

3-3.

Figure 3-3 Setting communication parameters

5. Press Enter until the command line prompt of the user view, such as <Enterprise AP>, is

displayed. Then, you enter the user configuration interface. You can run commands to

configure the AP. Enter a question mark (?) whenever you need help.

Huawei Indoor Access Points

Hardware Installation and Maintenance Guide 3 Logging In to the AP

Issue 08 (2014-04-10) Huawei Proprietary and Confidential