User's Manual

Table Of Contents

Figure 5-2 Stripping a power cable (OT terminal)

NOTICE

l When you strip a power cable, do not damage the conductor of the cable.

l If the bare crimping terminal is not provided by Huawei, the value of L1 is 1 mm (0.04 in.)

to 2 mm (0.08 in.) greater than the value of L.

Table 5-1 Mapping between the cross-sectional area of the conductor and the value of L1

Cross-

Sectional Area

of Conductor

(mm

(in.

))

Value of L1 (mm

(in.))

Cross-Sectional

Area of Conductor

(mm

(in.

))

Value of L1 (mm

(in.))

1 (0.002) 7 (0.28) 10 (0.015) 11 (0.43)

1.5 (0.002) 7 (0.28) 16 (0.025) 13 (0.51)

2.5 (0.004) 7 (0.28) 25 (0.039) 14 (0.55)

4 (0.006) 8 (0.31) 35 (0.054) 16 (0.63)

6 (0.009) 9 (0.35) 50 (0.077) 16 (0.63)

NOTE

If you are proficient in assembling OT terminals and power cables, you can obtain the value of L1 by

comparing the part to be crimped with the power cable.

Step 2 Put the heat-shrinkable (A) tubing onto the bare crimping terminal, as shown in Figure 5-3.

Huawei Indoor Access Points

Hardware Installation and Maintenance Guide 5 Appendix

Issue 08 (2014-04-10) Huawei Proprietary and Confidential