User's Manual

Table Of Contents

Figure 5-3 Putting the heat shrink tubing onto the bare crimping terminal

Step 3 Put the OT terminal onto the exposed conductor, and ensure that the OT terminal is in good

contact with the insulation of the power cable, as shown in Figure 5-3.

NOTICE

After the conductor is fed into the OT terminal, the protruding part of the conductor, or L2 in

Figure 5-3, must not be longer than 2 mm (0.08 in.).

Step 4 Crimp the joint parts of the bare crimping terminal and the conductor, as shown in Figure 5-4.

NOTE

The shapes of crimped parts may vary with the crimping dies.

Figure 5-4 Crimping the joint parts of the bare crimping terminal and the conductor (OT

terminal)

Huawei Indoor Access Points

Hardware Installation and Maintenance Guide 5 Appendix

Issue 08 (2014-04-10) Huawei Proprietary and Confidential