User's Manual

Table Of Contents

Step 5 Push the heat shrink tubing (A) towards the connector until the tube covers the crimped part,

and then heat the tube by using a heat gun, as shown in Figure 5-5.

Figure 5-5 Heating the heat shrink tubing (OT terminal)

NOTICE

When you heat the heat shrink tubing, do not heat it too long.

----End

Assembling the JG Terminal and Power Cable

Context

Figure 5-6 shows the components of a JG terminal and a power cable.

Figure 5-6 Components of a JG terminal and a power cable

A. JG terminal B. Heat-shrinkable tube C. Insulation layer of a power cable D. Conductor of a power cable

Huawei Indoor Access Points

Hardware Installation and Maintenance Guide 5 Appendix

Issue 08 (2014-04-10) Huawei Proprietary and Confidential