User's Manual

Table Of Contents

Context

Figure 5-15 shows the components of an RJ45 connector and a shielded Ethernet cable.

Figure 5-15 Shielded RJ45 connector and cable

A. Jacket of connector B. Metal shell of connector C. Wire holder of connector D. Plug of connector

E. Jacket of Ethernet cable F. Shield layer of Ethernet cable G. Twisted-pair wires -

Procedure

Step 1 Fit the jacket of the connector onto the Ethernet cable, as shown in Figure 5-16.

Figure 5-16 Fit the jacket of the connector onto the Ethernet cable

Step 2 Remove

a 30 mm (1.18 in.) long section of the jacket, cut off the nylon twine inside the jacket,

and cut a 5 mm (0.20 in.) cleft in the jacket, as shown in Figure 5-17.

Huawei Indoor Access Points

Hardware Installation and Maintenance Guide 5 Appendix

Issue 08 (2014-04-10) Huawei Proprietary and Confidential