User's Manual

Table Of Contents

Figure 5-47 Crossing two terminals

NOTICE

If the two terminals are different in size, place the smaller one above the bigger one. A

maximum of two terminals can be installed on a post.

l To remove an OT terminal, loosen the screw in the counterclockwise direction.

----End

Installing the Cord End Terminal

Procedure

Step 1 Hold a cord end terminal upright and place it on a terminal jack, as shown in Figure 5-48. To

ensure bump contact and dense connection, place the plain side of the terminal outwards.

Figure 5-48 Placing a terminal on a terminal jack vertically

Huawei Indoor Access Points

Hardware Installation and Maintenance Guide 5 Appendix

Issue 08 (2014-04-10) Huawei Proprietary and Confidential