User's Manual

Table Of Contents

Step 2 Insert

the terminal into the jack vertically, and fasten the terminal by turning the matching screw

in the clockwise direction, as shown in Figure 5-49.

Figure 5-49 Feeding the terminal into the jack

NOTICE

l Ensure that the exposed section of the terminal should be less than 2 mm (0.079 in.) in length.

l Do not press the insulation of the terminal.

l Insert only one terminal into one jack.

Step 3 Move the cable slightly and ensure that it is securely connected.

Step 4 Before you remove a cord end terminal, loosen the screw in the counterclockwise direction.

----End

Installing Ethernet Adapters

Installing a Shielded Ethernet Connector

Procedure

Step 1 Hold the male and female connectors, with the male connector facing the female connector, as

shown in Figure 5-50.

Huawei Indoor Access Points

Hardware Installation and Maintenance Guide 5 Appendix

Issue 08 (2014-04-10) Huawei Proprietary and Confidential