User's Manual

Table Of Contents

Figure 5-75 Installing a new mould in the COAX crimping tools

NOTICE

Keep the short side of the mould inwards and the long side outwards, with the teeth of the mould

aligning from the larger size to the smaller size.

Step 5 Hold

the handles of the COAX crimping tools tightly to match the mould and the jaw completely.

Align the screw holes, as shown in Figure 5-76.

Figure 5-76 Aligning the screw holes

Step 6 Hold

the handles of the COAX crimping tools with one hand. Tighten the two fastening screws

in the clockwise direction. Figure 5-77 shows the mould installed in the COAX crimping tools.

Huawei Indoor Access Points

Hardware Installation and Maintenance Guide 5 Appendix

Issue 08 (2014-04-10) Huawei Proprietary and Confidential