User's Manual

Installing the AP
Ceiling-mount the AP6010DN using the sheetmetal wall-mounting bracket:
1. Remove the ceiling, determine locations of mounting holes based on the distance between two installation holes,
use the hammer drill to drill holes, and fix the wall-mounting bracket to the ceiling.
2. Align the cucurbit holes at the rear side of the AP with four screws on the wall-mounting bracket and secure the AP.
Adjustable
buckle
Ceiling
M4*30 screw
35mm
Adjustable buckle
Ceiling
Wall-mounting
bracket
Ensure that the AP is correctly installed on the wall-mounting bracket and there must be 20 cm space above and around
the AP for cooling air circulation.
Mounting the AP6010DN to the T-rail using the sheetmetal wall-mounting bracket:
2. Align the cucurbit holes at the rear side of the AP with
four screws on the wall-mounting bracket and secure the
AP.
T-rail
Adjustable buckle
1. Use screws to fix the adjustable buckle to the wall-
mounting bracket, hook the adjustable buckle to the T-
rail, and secure the screw on the adjustable buckle to
fasten the wall-mounting bracket and T-rail.
NOTE
To prevent unauthorized personnel from moving the AP, lock the AP using the security lock and determine the position
for installing the security lock. When the sheetmetal wall-mounting bracket is used, fasten the security lock to the wall-
mounting bracket or other immovable object. The following figure shows the security lock. The carrier should purchase
the security lock.
Lock hole
Security lock
M3*6 screw
CAUTION
5