User's Manual

Table Of Contents

Context

Figure 5-15 shows the components of an RJ45 connector and a shielded Ethernet cable.

Figure 5-15 Shielded RJ45 connector and cable

A. Jacket of connector B. Metal shell of connector C. Wire holder of

connector

D. Plug of connector

E. Jacket of Ethernet cable F. Shield layer of Ethernet

cable

G. Twisted-pair wires -

Procedure

Step 1 Fit the jacket of the connector onto the Ethernet cable, as shown in Figure 5-16.

Figure 5-16 Fitting the jacket of the connector onto the Ethernet cable

Step 2 Remove a 30 mm (1.18 in.) long section of the jacket, cut off the nylon twine inside the

jacket, and cut a no more than 5 mm (0.20 in.) cleft in the jacket, as shown in Figure 5-17.

AP6050DN & AP6150DN

Hardware Installation and Maintenance Guide

5 Appendix

Issue 03 (2016-09-30) Huawei Proprietary and Confidential