User's Manual

Table Of Contents

Console

Default

Table 1-1 describes interfaces on the AP8030DN and AP8130DN.

Table 1-1 Descriptions of interfaces

No. Name Description

1 GE0/PoE 10/100/1000M bit/s interface: connects to the

wired Ethernet. The interface can connect to

a PoE power supply to provide power for the

AP.

2 GE1 10/100/1000M bit/s interface: connects to the

wired Ethernet. The interface can't connect to

a PoE power supply to provide power for the

AP.

3 SFP Connects an optical fiber to the AP. An

optical module must be installed first.

4 5G antenna interface Connects a 2.4GHz antenna to the AP to send

and receive service signals.

5 2.4G or 5G antenna

interface

Connects a 2.4GHz or 5GHz antenna to the

AP to send and receive service signals.

6 Console Console: Console interface

7 Default Reset button: restores factory settings and

restarts the AP if you hold down the Reset

button for more than 3 seconds.

NOTE

The Reset button is protected by a waterproof

screw. Before pressing the Reset button, remove

the waterproof screw. Keep the screw properly and

install it again after pressing the Reset button.

8 Security slot Connects to a security lock.

9 Device ground screw Connects a ground cable to the AP.

10 Ground screw for the

surge protective

device

Connects the AP to the ground point of an

external surge protective device.

Huawei AP8030DN & AP8130DN

Hardware Installation and Maintenance Guide

1 AP8130DN & AP8030DN Overview

Issue 03 (2015-05-18) Huawei Proprietary and Confidential