Users Manual
Table Of Contents
- 1 Product overview
- 2 Setup
- 3 Connecting to your router's Wi-Fi network
- 4 Configuring your router
- 5 Optional configurations
- 6 Additional information
- 7 FAQs
- 8 Troubleshooting
- Why is the indicator red after I have finished configuring the router?
- Why is the indicator status steady on cyan, blue, or yellow, but the indicator is off?
- Why can't I access the router's web-based management page?
- 1. Ensure that your computer is connected to the router through an Ethernet cable or Wi-Fi.
- 2. Ensure that your computer is set to obtain an IP address and DNS server address automatically.
- 3. Restart your browser, or try using another browser.
- 4. If the problem persists, restore the router to its factory settings.
- 9 Safety information
- 10 Legal Notice
9
6 Additional information
If you are experiencing any issues with the router:
Restart the router.
Refer to the help section on the web-based management page.
Restore the router to its factory settings.
Contact your network service provider.
Please visit http://consumer.huawei.com/en/support/hotline for recently
updated hotline and email address in your country or region.
7 FAQs
How do I restore factory settings?
When the router is turned on, press the reset button for approximately 3
seconds using a pointed object until the
indicator starts to blink.
Restoring factory settings will clear all customized settings. Proceed with
caution.
How can I connect to the router using Wi-Fi Protected Setup
(WPS)?
To connect a WPS-enabled device to your router using the WPS button:
1. Press and hold the WPS button on the router for at least 2 seconds until
the
indicator starts to blink.
2. Enable WPS on your device within 2 minutes to connect to the router's
Wi-Fi network.
The illustrations in this guide are for reference purposes only and may not
reflect the exact appearance of your product. Please contact your network
service p
rovider for more detailed information.
华为信息资产
仅供CTC使用
严禁扩散