User's Manual

Thank you for choosing this Wireless Modem.
Note:
This manual briefly describes the appearance, the preparation and the
process for installing/uninstalling.
Getting to Know your Wireless Modem
The following figures show the appearance of the Wireless Modem. The
actual product may differ.
n Micro SD card slot
Hold the Micro SD card.
o USB connector
Connect to the USB interface of the PC or the charger.
p Power switch
Press and hold it to power on or off the Wireless Modem.
q WiFi/WPS switch
z Press it to enable or disable the WiFi (Wireless Fidelity).
Press and hold it to enable or disable the WPS (Wi-Fi Protected Setup).
z
r Dial key
Press and hold it to set up a connection by dialing up or tear down a
connection.
s Battery_button
the battery cover. Press and hold it to open
t Signal indicator
z Off: The signal is inexistent.
Fast blinking in re
z d: The USIM/SIM card does not exist or the PIN code
.
n: The signal strength is strong.
ireless Modem is in the roaming state.
led.
bled.
S SPA (HSDPA/HSUPA) data service connected.
is not verified.
z Steady on and in red: The signal strength is weak.
z Steady on and in yellow: The signal strength is medium
z Steady on and in gree
u Roam indicator
z Off: The Wireless Modem is not in the roaming state.
z Blinking in red: The W
v WiFi indicator
z Off: The WiFi and WPS are disab
z Blinking: The WPS is enabled.
z Steady on: The WiFi is ena
w Mode indicator
z
Blinking in green: Registering with the 2G network.
Double blinking in green: The network is inexistent.
z
Steady on and in green: 2G data service connected. z
Blinking in blue: Registering with the 3G network. z
z
Steady on and in blue: WCDMA data service connected.
z teady on and in cyan: H
Battery indicator
z Blinking: The battery is being charged.
Fast blinki
z ng in red: The battery power level is very low a
charged.
nd need to be
d in green: The battery power level is enough.
ime to
z
z
Steady on and in yellow: The battery power level is normal.
Steady on and in red: The battery power level is weak.
z
z Steady on an
Note:
Press the Dial key and Power switch at the s
z ame time. The device
changes to the forcible downloading state.
Press and hold WiFi/WPS swit
z ch and Power switch at the same t
restore the factory defaults.
If the device has not been accessed for 10 minutes, the WiFi is

Summary of content (4 pages)