User's Manual

RRU3278

Installation Guide

8 Installing RRU Cables

Issue 05 (2017-03-10)

Huawei Proprietary and Confidential



Before wrapping waterproof tape, stretch the tape evenly until the length of the tape becomes twice

its original length.



Do not stretch the PVC insulation tape when wrapping the PVC insulation tape.



Wrap each layer of tape around the connector tightly and neatly, and ensure that each layer of tape

overlaps more than 50% of the preceding layer. Ensure that neighboring layers are stuck to each

other.



Ensure that the adhesive surface of the tape overlaps the lower layer.



When cutting off the cable ties, reserve a redundant length of 3 mm (0.12 in.) to 5 mm (0.2 in.).

Figure 8-21 Waterproofing the connector on the AISG multi-wire cable

(1) Waterproof tape

(2) PVC insulation tape

d. Route the cable by referring to section "Cabling Requirements". Then, use the cable

tie to secure it.

e. Label the installed cable by referring to Attaching an L-Shaped Label.

----End

8.8 Installing an RRU Alarm Cable

This section describes how to install the alarm cable for a remote radio unit (RRU).