P40 User Guide-(ANA-LX4&NX9,EMUI10.1_03,en-us)

Table Of Contents
2 In the list of Paired devices, touch next to the name of the device you wish to unpair,
then touch Unpair.
Mobile Data
Connect to Mobile Data
1 Make sure that mobile data is available on your SIM card.
2 Connect to mobile data using either of the following methods:
Swipe down from the status bar to open the notication panel, then swipe down
further to show all shortcut switches. Touch to enable Mobile data.
Go to Settings > Mobile network > Mobile data and enable Mobile data.
To conserve battery power and reduce data usage, disable the mobile data service when you
don't need it.
Enable 5G
5G is only available in some countries and regions.
Not all devices support 5G.
5G refers to the fth generation of mobile communications technology. Compared with a 4G
network, a 5G network has a higher data transmission rate and a shorter delay.
When two SIM cards are inserted, only the default mobile data SIM will support 5G, while
the other will only support 4G/3G/2G.
1 5G service depends on the support of your mobile carrier and its deployment of relevant
services. Please contact your carrier to activate the 5G service.
2 If your phone has two SIM cards inserted, go to Settings > Mobile network > SIM
management and set SIM 1 or SIM 2 as the default mobile data SIM.
3 Go to Settings > Mobile network > Mobile data and enable 5G for the default
mobile data SIM.
5G service may be unavailable in certain areas due to frequency interference in the carrier
network.
Manage SIM Cards
You can enable or disable SIM cards and name them for easier identication.
Enable or Disable a SIM Card
Go to Settings > Mobile network > SIM management, and turn the switch for a SIM
card on or o according to your preferences.
Settings
148