Quick Start Guide

Installing an AP
● Select an appropriate installation position and leave space above and around the device for cooling air circulation.
● Outdoors APs are used for hotspot coverage and often installed against walls or poles. The pole diameter is 30 to 114 mm.
AP6510DN dimensions (unit: mm) without a backplane support
Recommended AP6510DN installation space (unit: mm)
● Installing the AP6510DN against a Wall:
330 83
306
Hexagon
socket head
cap screw
Field strength
场强示意
1. Fix the wall-mounting bracket to the wall, adjust the
installation position, and use the marker, level, and
measuring tape to mark the drilling positions where
expansion bolts are installed.
2. Use #8 drill bit to drill 35–40 mm deep holes in the drilling
positions and install expansion bolts. Screw the nut into the
expansion tube, hammer the expansion bolt into a hole until
the flat washer is flattened against the wall, and remove the
nuts, spring washer, and flat washer in order.
Flat washer
Spring washer
Nuts
3. Use four M4*14 hexagon socket head cap screws to fasten the wall-mounting bracket to the AP.
4. Pinch the wall-mounting bracket on the expansion
bolts, and fasten the Flat washer, spring washer, and
nuts in order.
5. Slide the AP into the wall-mounting bracket to complete
installation.
4
64mm
37mm