TalkBand B6 Online Help-(FDS-B19,01,en)
Table Of Contents
- Contents
- 1 Getting Started
- 1.1 Powering on, Powering off, and Restarting
- 1.2 Charging your band
- 1.3 Removing and replacing the ear tip
- 1.4 Adjusting or Replacing the band's strap
- 1.5 Wearing your band
- 1.6 Pairing the band with the phone
- 1.7 Buttons and gestures
- 1.8 Setting the time zone and language
- 1.9 Setting dual time zones
- 1.10 Checking the band's version
- 1.11 Updating your band
- 1.12 Viewing the Bluetooth name, MAC address, and Serial Number
- 1.13 Resetting the band to factory settings
- 1.14 Supported features when the band is connected to different phones
- 1.15 Supported features when the band is not paired with any phones
- 1.16 Water and dust resistance level
- 2 Application management
- 2.1 Do Not Disturb
- 2.2 Using the Stopwatch
- 2.3 Using the Timer
- 2.4 Using the Flashlight
- 2.5 Setting an alarm
- 2.6 Turning the screen on and off
- 2.7 Adding favorites
- 2.8 Managing watch faces
- 2.9 Setting vibration strength
- 2.10 Receiving weather reports
- 2.11 Find My Phone
- 2.12 Controlling music playback
- 2.13 Remote camera shutter
- 2.14 Managing dual phones
- 3 Bluetooth calling
- 4 Workout monitoring
- 5 Health management
- 6 Notifications
NO TE
● Make sure that GPS and Location are enabled in the notication panel of the phone and
that Huawei Health has been granted the Location permission. More open areas are
better for getting a GPS signal.
● For versions earlier than EMUI 9.0, select GPS, Wi-Fi, and mobile networks or Wi-Fi
and mobile networks as positioning mode instead of Use GPS only.
● The weather information displayed on your watch may
dier slightly from that
displayed on your phone, since the information is collected from dierent weather
service providers.
2.11 Find My Phone
Swipe up or down on the home screen of the band and touch
, or enter the
app list and touch Find Phone. If your phone is within the Bluetooth range, it will
play a ringtone (even in Silent mode) to notify you of its whereabouts.
Touch the Find Phone screen on your band to disable this feature.
NO TE
● Ensure that the band and the phone are properly connected, your phone is powered on,
and the Huawei Health app is running in the background.
● The Find Phone feature will ring the phone for 10 seconds and the band will prompt you
with a message reading Stopped ringing if no operation is performed. The bands screen
will then turn
o after 30 seconds.
2.12 Controlling music playback
NO TE
● Controlling music playback is only supported on phones running Android 5.0 or later.
● You can use your band to control music playback with third-party music apps on your
phone including NetEase Music.
● You can listen to music during workouts. To do this, swipe left on the screen to access
the music player. (You need to start the music on the phone
rst).
1. Open the Huawei Health app, go to the device settings screen, touch Music,
and enable Control phone music.
2. After you play a song on your phone and swipe on the watch face screen, you
can
nd the music playback control screen. You can pause, resume, and
switch the music being played. When you are wearing the earphone and the
band screen is turned
o, double-tap the watch face of your band to pause
the music playback. Swipe up or down on the screen to adjust the volume.
2.13 Remote camera shutter
1. Connect your band with your phone and ensure that the Huawei Health app
is running in the background.
2. On your band, enter the app list and select Remote shutter. Camera will then
open on your phone at the same time.
HUAWEI TalkBand B6 Online Help
HUAWEI TalkBand B6 Online Help 2 Application management
Issue 01 (2020-07-31) Copyright © Huawei Technologies Co., Ltd. 19