User manual

Table Of Contents
If your phone has two SIM cards installed, congure the settings for SIM 1 and SIM 2
respect
ively.
More Connections
Enable or Disable Airplane Mode
When taking a ight, you can enable Airplane mode if required to do so by the airline. In
Airplane mode, y
our phone will not be able to make calls, send or receive SMS messages, or
use mobile data, but all other functions will be available.
You can enable or disable Airplane mode using either of the following methods:
Swipe down from the status bar to open the notication panel, then swipe down again to
display all shortcuts. Touch
to enable or disable Airplane mode.
Go to Sett
ings > Mobile network, and enable or disable Airplane mode.
When Airplane mode is enabled, Wi-Fi and Bluetooth will automatically be disabled. You can
re-enable them if allowed to do so by the airline.
Please make sure your device has been updated to the latest system version.
Introduction to NFC
Near Field Communication (NF
C) is a short-range wireless communications technology that
allows mobile and other electronic devices to connect in countless ways, allowing you to
transfer data and make mobile payments easily.
Not all devices support NFC.
Enable Read and write/P2P on the NFC settings screen if available. This feature may
vary depending on your carrier.
Enable or Disable NFC
You can enable or disable NF
C as follows:
Swipe down from the status bar to open the notication panel, swipe down further to show
all shortcut switches, then enable or disable NFC. You can touch and hold NFC to access
the settings screen.
Go to Settings > More connections > NFC, then enable or disable NFC.
Share Data Using Huawei Beam
You can hold the NFC sensors of two Huawei devices against each other to quickly transfer
data between them, without the need to pair the devices.
1 Go to Settings > More connections and enable NFC and Huawei Beam on the devices of
both the sender and recipient.
Settings
140