SmartAX MT883 ADSL CPE Quick Start 1 Connecting the Cables 1 POWER #### #### #### 4 2 LAN RESET ADSL 3 1 Telephone jack on the wall 2 Splitter 3 Telephone 1 4 Computer
To connect the cables, do as follows: Step 1 Connect the telephone jack on the wall to the LINE interface on the splitter with a telephone line. Connect the telephone to the PHONE interface on the splitter with a telephone line. #### #### #### PHONE LINE Step 2 Connect the ADSL interface on the MT883 to the Modem interface on the splitter with a telephone line.
POWER LAN RESET ADSL Step 4 Connect the POWER interface on the MT883 to the USB port on the computer with a dedicated USB cable.
2 Getting Started Step 1 Power on the computer. Step 2 Press the power button on the top of the MT883. After you power on the MT883, the ADSL indicator blinks, which indicates that the MT883 is being activated. After the ADSL indicator stops blinking, the POWER and ADSL indicators turn on, which indicates that the MT883 is working properly.
3 Configuring the MT883 After you enable the embedded dial-up function of the MT883, when the MT883 is not used for the network access, power off the MT883. Otherwise, even if you have shut down your computer, the network operator may still charge you for the network access. Step 1 Log in to the Web configuration page. 1. Launch the Internet Explorer on the computer. Enter http://192.168.1.1 in the address bar and press Enter. 2.
Indicator Status ADSL Blinking The MT883 is being activated. On The MT883 is activated. LAN Description Off The MT883 is powered off. Blinking Data is being transmitted through the Ethernet interface. On The Ethernet connection is established. Off The Ethernet connection is not established. Copyright © Huawei Technologies Co., Ltd. 2008. All rights reserved.
