User manual

Table Of Contents
1 Swipe down from the status bar to open the notication panel, then touch to enable
Bluetooth on your phone.
2 Refer to the snorkeling case user guide to enable Bluetooth on the case, and place the
case close to your phone.
3 Your phone will automatically detect the snorkeling case and prompt you to connect to it.
4 After the connection is set up, install the snorkeling case according to the instructions and
ensure that the case is airtight. Double-press the Power button to enter Underwater
mode. You can then:
Take a photo: Press the shutter button.
Take a burst photo: Press and hold the shutter button.
Zoom: Move the zoom joystick.
Switch between photo and video modes: Double-press the Power button.
Pause/Resume recording: Press the shutter button when recording.
End recording: Double-press the Power button.
Switch between the front and rear cameras: Press the Power button three times.
Turn the screen on or
o: Press the Power button.
Disable Bluetooth on the snorkeling case: Press and hold the Power button for 2
seconds.
5 After you have nished shooting, take your phone out of the water and follow the
onscreen instructions to exit Underwater mode.
Connect to a Profoto Studio Light
Your phone can connect to a Profoto studio light through Bluetooth so you can create
professional images easily, without the need for extra apps.
Currently, only Profoto C1 and C1 Plus studio lights for smartphones are supported.
1 Swipe down from the status bar to open the notication panel, then touch to enable
Bluetooth.
Camera and Gallery
82