Quick Start Guide-(WS8100,02,en-us)
10
Connect the router to the power supply and wait until the
router completes the startup process. Use a needle or pin
to press the
RESET
button on the router for more than two
seconds until the indicator light goes out. Wait for the router
to complete the restart process. When the indicator turns red,
this indicates that the router has been restored to its factory
settings.
If the problem persists, restore the router to its factory settings
and follow the instructions in this guide to reconnect the cables
to the factory settings so that it/they can automatically connect
You can connect the router in either of the following ways:
router (new or restored to factory settings) to the LAN port
cable.
Step 1: Place the add-on router (new or restored to factory
Mesh 3 and connect it to the power supply.
Step 2: When the indicator on the HUAWEI WiFi Mesh
H
button on it. Wait until the
indicator on the add-on router shows it is connected to the
network.
Step 3: For broader coverage, disconnect the add-on router
from its power source, then place the router within a 10 m