User's Manual

10
USER MANUAL
Chapter IV Product Working Requirements
4.1 Power requirements
The camera can choose to use 12V/2A switching power adapter or POE power
supply. The voltage parameters are shown in Table 4-1.
Table 4-1 Power supply voltage parameter
Voltage requirements
POWER
DC12V (±10%)
average value：7.0W
Max：7.2W
note:
1. Using an incorrect power supply may damage the camera;
2. Do not use a power supply with a voltage greater than DC12V (±10%);
3. The camera only supports the following three working methods, and does not
support working scenarios where wired and wireless are used at the same time:
(1) WI-FI connection network and DC12V power supply mode;
(2) POE power supply and wired network connection;
(2) Wired network and DC12V power supply;
4.2 Storage and working environment requirements
Working temperature: 0°C~45°C;
Working humidity: 20~80%;
Storage temperature: -20°C~50°C;
Storage humidity: 20~80%;
Note: An effective heat dissipation method must be provided to maintain a stable indoor
temperature. The following guidelines must be followed. In any case, monitor the indoor
temperature and ensure that the temperature does not exceed 50 °C. Fans can be used
for airflow heat dissipation.
4.3 Camera connector
The binocular passenger flow product leads out two connectors on the rear side,
namely DC JACK and Ethernet. Among them, the Ethernet interface is the data
transmission and POE power supply interface, and the DC JACK is the 12V power
supply interface.
note:
1. Using a power supply higher than 12V (±10%) will damage the product;
2. It is recommended to use standard POE power supply equipment, non-standard
POE power supply equipment will cause damage to the camera;