User Manual

Installation Instructions A245
Flora Chandelier 10-3033 10-3035 & 10-3037 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
24613
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products and
options.
To Install the Canopy (Figure 1)
Component Parts
A Ground Screw
B Crossbar
C Lock Nut
D Nipple
E Canopy
F Canopy Loop
G Loop Collar
H Fixture Loop
Caution: Be sure power is off at the main breaker box prior to
installation
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar (B) to
the electric box (see illustration).
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
3. Thread the nipple (D) into the crossbar (B) and secure with lock nut
(C); slide canopy (E) over nipple (D), and attach the canopy loop (F)
to the nipple (D). Adjust the nipple to proper length to ensure a snug
canopy fit before proceeding.
4. Attach one end of the chain to the fixture loop (H). Lace the wire
through every other link of the chain to the end. Slip wires and chain
through the collars and canopy (G, F & E). Fasten the chain to the
canopy loop (F) then slip wires through the loop and nipple, into the
electric box. Make sure to provide enough slack in the wire to ensure
weight of fixture is supported by the chain.
5. Using suitable wire connectors (not provided) connect fixture wires to
supply wires (white to ribbed side of the fixture s cord, black to
smooth side). Run a pigtail lead from crossbar ground screw (A) to
the junction box and connect all ground wires (bare copper or green to
bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.
6. Raise canopy (E) to the ceiling and secure loop collar (G) to canopy
loop (F).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)