User Manual

Assembly & Installation Instructions A153
New Town Eight-Light Chandelier 10-3280 & 10-3285 Page 1 of 2
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
21211
To Install to Ceiling (Figure 1)
Component Parts
A Fixture
B Stud (2)
C Ceiling Bracket
D Canopy Loop (2)
E Crossbar
F Lag Screw (4)
G Hex Nut (2)
H Canopy
I Loop Collar (2)
J Chain (2)
K Fixture Loop
Caution: Be sure power is off at the main breaker box prior to
installation
1. Attach one end of the chains to the fixture loops (K). Lace the wire
through every other link of the chain (J) to the end.
2. Remove loop collar (I) from canopy loop (D).
3. Slide loop collar (I) and canopy (H) over canopy loop (D).
4. Fasten the chains to the canopy loops (D) and slip wires through the
canopy loop (D). Make sure to provide enough slack in the wire to
ensure weight of fixture is supported by the chain.
5. Using four lag screws (F) attach crossbar (E) to a structural member
in the ceiling, centering the crossbar over the outlet box. We've
supplied lag screws with your fixture; however, different materials
and/or construction methods may require different fasteners. If in doubt,
contact a qualified electrician. Do not attach crossbar directly to outlet box.
6. Raise fixture to ceiling allowing loop collar (I) and canopy (H) to rest
against chain (J), align studs (B) in crossbar (E) with holes in ceiling bracket (C).
7. Thread hex nut (G) onto studs (B) and tighten.
8. Using suitable wire connectors (not provided) connect fixture wires to supply (white to white and black to black,
and bare copper to bare copper or green supply). Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
9. Raise canopy (H) to the ceiling and secure with loop collar (I) to canopy loop (D).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)