Installation Sheet

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.

We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.

HUBBARDTONFORGE.COM

-, -   

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

27950 C

Installation Instructions

To Install the Canopy (Figures 1 & 2)

(Continued)

7. Raise canopy (D) and fixture (F) close to ceiling. Align holes

in canopy (D) with holes in crossbar (A) and secure with (2)

#8 screws (E).

8. If fixture needs to be lowered to achieve desired height,

push up on canopy gripper (G) and gently pull down on

supply/support cable (H).

Note: Excessive movement of cable through the gripper could

cause cable to fray slightly. Adjustment is for initial installation only.

Repeated adjustment is not recommended.

To Install Glass (Figure 3)

Component Parts

F Fixture

I Glass

J Thumb Screws

1. Install bulb (not included). Be careful not to touch bulb with

bare hands; oil from the hands will dramatically reduce bulb

life.

2. Loosen the three thumb screws (J). It is not necessary to

remove them from the xture.

3. Raise glass (I) until groove is aligned with thumb screws (J).

4. Tighten the three thumb screws (J) equal amounts until

snug with glass (I). Be careful not to over tighten.

5. Restore electricity at main breaker.

A320

Erlenmeyer Pendants 161060 & 161065

Page 2 of 2

(Figure 3)