Installation Sheet

42338

ASSEMBLY & INSTALLATION INSTRUCTIONS

Vela Sconce 203330

B392

To Install Fixture (Figure 1)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND

PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with

applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.

3 OF 4

1. Carefully unpack the xture (A) from the carton.

2. Take off rubber band and remove mounting bracket

(B) from xture (A).

3. Place the mounting bracket (B) over the electrical

box being sure to hold it level. Line up holes in

mounting bracket with holes in electrical box. With

a pencil, mark the location of all mounting holes

in the mounting bracket on the wall behind. Set

bracket aside.

4. Drill 1/4" holes in the locations marked on the wall.

Place the tapered end of the anchors (C) into the

holes and gently tap them ush to the wall using a

light weight hammer.

5. Thread the wires in the electrical box through the

hole in the mounting bracket (B) while moving the

bracket into position. Using #10 screws (D), screw

the mounting bracket securely to the wall. Be careful

not to over-tighten or strip the anchors (C).

6. Attach a pigtail lead to the mounting bracket (B)

using the ground screw (E) and cupped washer (F)

found in kit bag.

7. Hold xture (A) close to wall. Using suitable wire

connectors (not provided), connect xture wires to

supply wires (white to white and black to black).

Connect all ground wires (bare copper or green to

bare copper or green).

8. Place xture (A) over mounting bracket (B). Secure

with #8 screws (G) on top and bottom of xture. Be

sure no wires are pinched between xture and wall.

9. See following page to complete installation.

CAUTION: MAKE SURE WIRE CONNECTORS ARE

TWISTED ON SECURELY, AND NO BARE WIRE IS

EXPOSED.

(Figure 1)