Installation & Assembly

MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING

CASTLETON, VERMONT USA | HUBBARDTONFORGE.COM

44708

ASSEMBLY & INSTALLATION INSTRUCTIONS

Shard Outdoor Sconce XL 302518

B423

1. Carefully unpack the xture (A) from the carton.

2. Plate assembly (H) is shipped installed. Remove plate by removing

the two plate screws (I) (Figure 1). Remove mounting bracket (B).

3. Using two machine screws (not provided) attach mounting bracket (B)

to the electrical box (Figure 2).

Note: A new electric box comes with screws. When replacing a fixture,

retain the existing screws for use with the new fixture.

4. Using the ground screw (E) and the cupped washer (F) found in kit

bag, secure a pigtail lead to the mounting bracket (B).

5. Hold the xture (A) close to the mounting bracket (B) and using suit-

able wire connectors (not provided), connect xture wires to supply

wire (white to white and black to black). Connect all ground wires

(bare copper or green to bare copper or green).

6. Apply a generous bead of a suitable caulking material (not provided)

to caulking lip (G) on the xture. Caulk should be applied around the

entire perimeter of the backplate (Figure 3).

7. Carefully tuck all wires behind xture and inside the mounting bracket

(B). Place xture rmly onto bracket and fasten with two #8 screws

Note: Be sure no wires are pinched between the wall and fixture.

8. Install the two #8 screws (C) in bottom of xture.

To Install Fixture (Figures 1, 2 & 3, following pages)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH

AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance

with applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products and options.

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON

SECURELY AND NO BARE WIRES ARE EXPOSED.

3 OF 5

(Figure 1)