Installation & Assembly

43614

ASSEMBLY & INSTALLATION INSTRUCTIONS

Sprig Semi Flush 128715

A591

(Figure 2)

GROOVE

To Install Glass (Figure 2)

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you

purchased this product. We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of

this xture.

4 OF 4

1. Unpack glass (I & J).

2. Install bulbs (H) (not included) into sockets (F).

3. Place glass (J) over the bulb (H).

4. Slide glass (J) into cup (G) until groove in glass lines up with thumb screws (K).

Note: Thumb screws are shipped in cups. It may be necessary to loosen thumb screws so glass can pass into cup.

Screws will not need to be removed completely.

5. Tighten thumb screws (K) evenly to secure glass (J).

Note: Do not overtighten screws as this could break glass.

6. Repeat steps for remaining small and large glass (I & J).

Figure 2 shows recommended glass locations.

7. Restore electricity at main breaker.