User's Guide

12
Getting Started
2.5 Registration (Pairing)
The Baby Unit is pre-registered to your Parent Unit. You do not need to
register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the
procedure below:
1. Press the button to access the menu.
2. Press the
<
LEFT button or
>
RIGHT button until
is highlighted, the
- (delete) / + (add) /
(view) / (scan) menu will display.
3. Press the
+
UP button or
-
DOWN button to select + (add), and press
the
button to conrm.
4. Camera 1 / 2 / 3 / 4 will display. Press the
+
UP button or
-
DOWN
button to select the desired Camera, and press the
button to start the
pairing process.
Note: If a camera is currently paired with the Parent Unit, its camera
location (with a * against it) cannot be selected for a new registration.
5. Press and hold the PAIR button on the back of the Baby Unit until
the Parent Unit nds the camera, beeps and PAIR OK appears on the
screen. The video from the camera will then appear.
Note:
A camera can only be registered to one Parent Unit at any one time.
NOTE
• An internal rechargeable battery (Lithium ion battery 2100mAh) allows
portability to the parent unit. The battery provides up to 4 hours operation of
the Parent Unit. We recommend charging the parent unit battery for at least 4
hours before rst use, and when the Parent Unit indicates the battery is low.
• When the battery is low, the battery icon turns RED, and the Parent Unit
will beep every 15 seconds. The battery needs to be recharged; it will take 4
hours to charge fully.
2.4 Desktop Stand of the Parent Unit
• Flip out the stand on the back
of the Parent Unit.