User's Guide
Table Of Contents
- _bookmark2
- 1. Safety Instructions
- 2. Getting Started
- 3. Using the Baby Monitor
- 3.1 Power on or off the Parent Unit
- 3.2 Turn off the Parent Unit screen
- 3.3 Night Vision Mode
- 3.4 Talk Mode
- 3.5 Adjust the speaker volume for Parent Unit
- 3.6 Zoom
- 3.7 Set Night Light
- 3.8 Adjust the LCD brightness of the Parent Unit
- 3.9 Set the alarm on the Parent Unit
- 3.10 Temperature Setting
- 3.11 Set the screen off time of the Parent Unit
- 3.12 Pair and replace extra new Baby Unit
- 3.13 Delete a Baby Unit
- 3.14 Multi-Camera Use
- 4. Wi-Fi® Internet Viewing
- 5. Disposal of the Device (environment)
- 6. Cleaning
- 7. Help
- 8. General Information
- 9. Technical Specifications
25
Help
English
7. Help
Display
No display
• Try recharging the battery pack.
• Reset the Units. Unplug both the Units' electrical power, then plug them
back in.
• Is the Unit switched on?
• Press and hold the ON/OFF button
0
on the Parent Unit for 3 seconds to
switch it ON.
• Is the correct camera selected? Change the camera number, if necessary.
• Is the video display turned on? Press the VIDEO ON/OFF button
V
to
turn it ON.
• When operating using batteries only, the display will go blank after 5
minutes or 15 minutes or 30 minutes to save power (depending on video
settings). The Unit is still active and will give you audio alerts. You can
reactivate the screen by pressing any button.
Registration
If the Baby Unit has lost its link with the Parent Unit
• If the Baby Unit is too far away it may be going out of range, so move the
Baby Unit closer to the Parent Unit.
• Reset both the Parent Unit and Baby Unit by disconnecting them from the
electrical power. Wait about 15 seconds before reconnecting. Allow up to
one minute for the Baby Unit and the Parent Unit to synchronize.
• See 2.3 Registration (Pairing), if there is a need to re-register the Units.
Interference
Noise interference on your Parent Unit
• Your Baby and Parent Units may be too close. Move them further apart.
• Make sure there is at least 1 to 2m between the 2 Units to avoid audio
feedback.
• lf the Baby Unit is too far away, it may be out of range. Move the Baby
Unit closer to the Parent Unit.