User's Guide
Table Of Contents
- _bookmark2
- 1. Safety Instructions
- 2. Getting Started
- 3. Using the Baby Monitor
- 3.1 Power on or off the Parent Unit
- 3.2 Turn off the Parent Unit screen
- 3.3 Night Vision Mode
- 3.4 Talk Mode
- 3.5 Adjust the speaker volume for Parent Unit
- 3.6 Zoom
- 3.7 Set Night Light
- 3.8 Adjust the LCD brightness of the Parent Unit
- 3.9 Set the alarm on the Parent Unit
- 3.10 Temperature Setting
- 3.11 Set the screen off time of the Parent Unit
- 3.12 Pair and replace extra new Baby Unit
- 3.13 Delete a Baby Unit
- 3.14 Multi-Camera Use
- 4. Wi-Fi® Internet Viewing
- 5. Disposal of the Device (environment)
- 6. Cleaning
- 7. Help
- 8. General Information
- 9. Technical Specifications
29
Help
English
General What is the
signicance of the
camera LED?
Pair / Setup state: LED is Flashing
Green.
Unconnected state: LED is Flashing
Red.
Connected state: LED is Solid
Green.
Green: The camera is live streaming.
LED Off - Power off / User turn off
by Camera App setting.
Connectivity
issues
I am not able to
access my Camera.
Please check if the Camera is within
Wi-Fi
®
range. Please try to move
the Camera closer to the router for
better Wi-Fi
®
connectivity and try
again.
Setting Up During setup on
devices for Android™
and iOS, I am not able
to nd my Camera
during the last step
and the setup fails.
Please reset the Camera to setup
mode and try again. Press and hold
the PAIR button on the side of the
camera until you hear a beep and
voice prompt ‘Ready for pairing’.
When the Camera LED is off, this
indicates that it is in setup mode.
Add camera in HubbleClub by
Hubble Connected App.
Connectivity
Issues
Even though I am
accessing my Camera
from the same
Wi-Fi
®
network, I
still nd my Camera
is shown as remote. I
can only access it for
5 minutes at a time.
Please check your wireless router
settings. For example, for Buffalo
brand routers there is an option
called Wireless Isolation. Please
disable this option.