User's Manual

(4) Start binding (This step is only required when first binding or replacing

the transmitter, you need to do it manually.)

1. Long press the aircraft bind button to enter the binding mode.

2. Press and hold the FN+Photo key combination to enter the binding mode,

put the aircraft close to the remote control to complete the bind.

Tips:

-The binding process has been completed in the factory. The aircraft can take

off directly.

-After entering binding mode, all 4 LEDs flash rapidly and become solid after

binding is successful.

-Please keep the remote controller at least 1 meter away from drone during

binding process.

3.3 Pairing The Aircraft

(1) Run X-HUBSAN 2.0 APP, and select the aircraft model.

(2) Short press, the aircraft power button, then press and hold for a few seconds

to turn it on.

(3) Short press the transmitter power button, then press and hold for a few

seconds to turn it on, connect the transmitter to your mobile device with the

RC cable.

To use the aircraft for the first time, you need to activate the aircraft first :

① Press battery switch to power on the aircraft.

② Press the remote control switch to connect to the mobile phone, and

wait for the remote control to connect the aircraft in success.

③ Open the mobile phone X-HUBSAN 2.0 APP, it will automatically jump

out of the activation interface.

④ The new user can register an account as the activation account, and the

old user who has logged in to the APP before can directly enter the

password to activate it.

Before Pairing After Pairing

Not connected

N00.0000000,E000.0000000

45.877503 , -106.123984，65m

Pi tch 0° Yaw 0°Ro ll 0°