User Manual

Rev 1.1 1/17
o You may leave the unit in “Call” mode and continue to enter
sequential preset calls. To leave “Call” mode, press the “Esc” key.
 Clear a PTZ Preset
o Press “Esc” key to return to main menu. Press the “Clear” key,
press a “Number” key and then the “Enter” key. To leave “Clear”
mode, press the “Esc” key.
 Send camera to its “Home” PTZ Position
o Press the “Home” key. Note: When in Pelco-P or –D, this button
will call preset 0, instead of Home. Pelco-P and –D do not provide
for a “Home” position. You must first set preset 0 to use this
feature with Pelco)
Notes on using presets with VISCA:
For your convenience, the HC-JOY-G2 uses the same preset numbers
whether ‘set’, ‘called’ or ‘cleared’ via hand-held IR remote, VISCA, Pelco-P
or Pelco-D. This is in contract to Sony’s traditional offset of -1 between IR
remote commands and VISCA commands. If you are used to Sony’s
traditional method, you no longer need to make this adjustment.
Keyboard/Joystick Configuration - LCD Menu
 Go to Main Menu or Backup up one Menu Level
o Press “Esc” key to return to main menu. Note: Repeated presses
may be required depending on how deep you are in a menu.
Note: Pressing the “Esc” key while not in a menu will change the
manual focus speed.
 Obtain Product Information
o Press the “Info” key.
o Use Joystick “Up” and “Down” to scroll through info (Model, Serial
Number, Keyboard ID, Key Sound setting).
 Configure Keyboard/Joystick
o Press and Hold the “Setup” key for 3 seconds.
o Enter the password. “8888” is the default password.
o Press the “Enter” key.
 Keyboard Menu
o “Set >>” Menu
o Move joystick “left” and “right” to select between 1(CAM) or
2(SYS)
o Press “Enter” key to confirm the choice.