User Manual

Ver 1.3 12/16
IR Remote Controller (Note: Some buttons do not operate for all camera models)
1. Reset
Restarts the camera and restores it to Factory
Default settings. (Note: Will delete all saved
settings and presets.)
2. Camera Selection
Select which Camera to control via IR: 1, 2 or 3
3. Preset Positions
1-9: Preset Positions
Set: Set a Preset Position
Clear: Clear a Preset Position
Call: Call a Preset Position
Note: If you want to set (or call) the first preset
position to 1, you simply press number key “1”,
then press ”Set” or “Call” to set (call) the
position.
4. Fast Zoom in/out Control Zone
+: Zoom in quickly
-: Zoom out quickly
5. Pan/Tilt Controller
Move Up
Move Down
Move Left
Move Right
Auto Pan (through full pan range)
6. Additional Function Zone
Model Dependent Functions
Not applicable to this model
7. Power Supply Switch
Switch for turning camera on/off
(i.e. Working mode vs. Stand-By mode)
7. OSD Menu Zone
Model Dependent Functions
Not applicable to this model
9. Slow Zoom In/Out Zone
+: Zoom in slowly
-: Zoom out slowly
10. Focus Control Zone
Auto: Turn on Auto Focus
Manual: Turn on Manual Focus
Far: Set focus at a farther distance (req Man
Focus)
Near: Set focus at a nearer distance (req Man
Focus)
11. Pan/Tilt Function Zone
Home: Go to camera’s Home position
Rev: Enable image flip for ceiling mounting
L-Limit: Sets left limit for Scan feature
R-Limit: Sets right limit for Scan feature
Scan: Auto pan to L&R limits
Tour: Auto tour of all saved presets