Owner's manual

ManualsBrandsHudson Robotics ManualsToolsRapidWash

Dispense Origin- This is the saved position of the dispense manifold when the

RapidWash begins to dispense. This position is calibrated with a 96 well teaching

plate. The position should be taught where each set of tips are centered in each

well of the plate (Figure 23).

Figure 23

Track/Nest Height- This Position should only be modified when the unit is used

with a TrackLink on our Lablinx system. This is the beginning position of the

nest, default is 0. When used with a track the position is taught just below the

bottom the track (Figure 26).

Figure 24

Grip Position- This position is only used when a nest with a gripper is attached to

the RapidWash. This is used for through track-based washing only. This is the

Position at which a plate is gripped by the nest before the washing procedure.

This Position is usually taught +5mm above the track (Figure 25)

The image cannot be d isplayed. Your computer may not h ave enough memory to open the image, or the image may have been co rrupted. Restart your computer, and then open the file again. If the red x still appears, yo u may have to delete the image and then insert it again.