Full Product Manual

Hudson® Pro® Bleach Backpack
©2020 Manufactured by H. D. Hudson
Manufacturing Company
Customer service is here to help! If you have any questions or concerns, do not return sprayer to the store.
Call 1-800-253-4642 or email [e-mail]
1-800-253-4642
[e-mail]
19002
Instructions
Tank capacity 4 Gallons
Pumping system Internal Piston Pump
Hose Reinforced vinyl hose
Working pressure (4-6) bar- (58-87) psi
Nozzle Adjustable poly nozzle
Net Weight 11.8 lbs
Seal Type Viton
Dimensions (inches) 14.57 x 8.66 x 22.44
Lifetime Consumer Warranty
PRODUCT SPECIFICATIONS
HOW TO ASSEMBLE
WARNING!!! THIS PRODUCT IS DESIGNED TO SPRAY CHEMICALS THAT MAY BE HARMFUL AND COULD CAUSE SERIOUS PERSONAL INJURY IF INHALED OR
BROUGHT INTO CONTACT WITH THE USER. FAILURE TO READ AND FOLLOW OPERATOR’S MANUAL INSTRUCTIONS BEFORE USE AND/OR MISUSE OF THIS
PRODUCT COULD RESULT IN EXPLOSIVE FAILURE WITH MAJOR INJURIES. Viton® is a registered trademark of DuPont Dow Elastomers
• ALWAYS water test sprayer before each use.
• ALWAYS wear long sleeve shirts, long pants, goggles, gloves and durable
shoes.
• ALWAYS read and follow label instructions for the chemicals to be applied
• AFTER USE release pressure and clean the sprayer after each use.
• ALWAYS release pressure in sprayer before servicing.
• DO NOT alter any components on the sprayer.
• DO NOT spray ammable, caustic (i.e. acids, chlorines),
corrosive or self-heating solutions with the sprayers.
• DO NOT ll sprayer with hot liquids-- 30°C/85°F MAX.
• DO NOT store liquids in the sprayer.
• See CDC.gov for dilution guidelines.
MAINTENANCE AND STORAGE
1. Remove the loose parts from inside
the tank. Parts will include the following:
• Wand
• Pump handle
• Nozzles/clips (under tank lid)
• Agitator (inside the tank)
• Lynch pin
• Cap
2. Attach agitator while pump is in the
tank. Unscrew and remove the lid and
lter, put hand into the tank and attach
agitator to the pump by sliding it onto
the hex shaped area. Rotate to lock it in
place. When installed it should be parallel
to the hose outlet (see images below for
placement).
Note: The agitator is optional for use and isn’t
mandatory for the unit to work properly.
3. Place the strainer back into the tank
opening and screw the lid on.
To ensure a good seal, turn lid counterclockwise until
it lines up with the threads. Then turn clockwise to
tighten down.
4. Place the pump handle on the lever
shaft located at the bottom of the tank
and secure it with the lynch pin.
5. Assemble the spray wand into the
shut-o󰀨 and tighten manually.
• After use, the sprayer should be properly cleaned and stored away from direct sunlight to prevent UV damage.
• After removing the piston lubricate the piston with a petroleum jelly before next use.
• Before storing for the winter, be sure that most of the liquid is completely drained from the tank, lines and air chamber.
• Leave ow control locked on.
• Regularly inspect hose, wand, pump, tank and ow control for wear, damage or leaks.
• Avoid excessive wear by regular lubrication and a prompt and thorough cleaning after each use.