Date Code Label Here Owner’s Manual for Battery Ride On © Copyright Huffy Corporation 2022 HUF_ERO_F150 07-27-21_m0910-EN EN This manual contains important safety, assembly, operation and maintenance information. Please read and fully understand this manual before operation. Save this manual for future reference. Always wear approved helmet and safety equipment when using this product.
Owner’s Manual Index Safety and Warnings............................................................................................2-6 Assembly and Parts...............................................................................................7-11 Operation............................................................................................................................12 Maintenance Repair and Service.........................................................
Here are basic, common sense safe riding practices you should read aloud to your child and anyone who may use the vehicle. It is the responsibility of the adult to educate the child, determine if they are fit to operate the vehicle, and supervise use. To avoid serious injury or death follow these safety rules and guidelines: • Adult assembly required. Choking hazard to children under the age of 3 years - contains small parts. Keep small children away when assembling. Keep poly bags away from child.
Warnings and Safety WARNING - TO AVOID SERIOUS INJURY: • • • • • • • • vehicle in loose dirt, mud, sand, or fine gravel may damage the electronics and gear box inside the vehicle. • Do not overload the vehicle. Do not drive in very hot weather, components may overheat. Do not allow water or other liquids to come in contact with the battery or other electric components. • Obey all local traffic and scooter riding laws and regulations. Do not tamper with the electrical system.
The following safety hazards may result in serious injury or death to the user of the vehicle: • • • • • • • • • • • • • • • • • Battery Charger is NOT to be used by Children. Rechargeable battery is only to be charged by adults. Battery Charger for Indoor use only. Use of a battery or charger other than the supplied rechargeable battery and charger may cause a fire or explosion. Only use the supplied rechargeable battery (or lead-acid or lithium suitable replacement) and charger with the vehicle.
Warnings and Safety Radio Frequency Information (if applicable) CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device or charger/adapter complies with Part 15 of the FCC Rules.
This Owner’s Manual may be made for several different style products. • Some illustrations may vary slightly from the actual product. • Follow instructions completely. • If the product has any parts that are not described in this manual, look for separate “Special Instructions” that are supplied with the unit. • All features, components and accessories are not included on all models. • Use the Index page to locate specific sections of this manual.
Parts Assembly Parts Assembly 12.Wheel axle 1pc 13 14 REMOVE PLASTIC TIES : • With car body up-side-down, cut plastic ties holding drive motor in place.
INSTALL REAR WHEEL SUPPORT: 2 ! • With car body up-side-down, position wheel support as shown. • Line up tabs with body slots and SNAP firmly and evenly into position. • Gently pull up to make sure it does not come loose. 1 a INSTALL REAR AXLE: 10 3 Assembly Assembly 10 • Rotate drive motor to align with axle hole of wheel support a. • Insert axle d through drive motor and wheel support. 12 INSTALL REAR WHEELS AND DRIVE MOTOR: • Place one spacer s as shown and place one wheel o on axle.
Assembly 6 Assembly 5 13 4 8 8 INSTALL FRONT WHEELS: INSTALL WINDSHIELD: • Place one washer f on each front axle as shown. • Place each wheel i on axle and push in until it SNAPS into place. • Gently pull out to make sure wheels do not come loose. • Position windshield r as shown so that tabs line up with slots in body. • SNAP windshield into place evenly and securely. • Gently pull up to make sure windshield does not come loose.
Assembly Assembly 10 9 3 1 7 2 INSTALL SEAT: INSTALL SIDE MIRRORS 1. Position front of seat so that the front NOTE: There are left and right mirrors. tabs fit into the car body slots. 2. Put seat back down into position as • Install both side mirrors so that they shown. snap into position as shown. 3. Slide Lock Lever over Lock button so that seat is locked into position. & 11 12 5 6 INSTALL DOOR WINDOWS: • • • • % Position right door windows as shown so that tabs line up with body slots.
Operation Operation A B C Safety belt Phone holder (if equipped) Open Tailgate Open Door 1. 2. 3. A • • • • Turn on Power Switch . Various sounds may also play. To move FORWARD, put Direction Switch to FORWARD position. Press Foot Switch - Vehicle moves forward. To STOP, remove foot from Foot Switch - Vehicle gradually stops with motor friction. To move in REVERSE, put Direction Switch to REVERSE position. Press Foot Switch - Vehicle moves in reverse.
GENERAL: The vehicle should be checked for damage, missing or badly worn parts before each use. If any part of the product does not operate properly – discontinue use. • Check the tightness of the fasteners before each use. Replace any fasteners that are damaged. • Inspect the product frequently. Failure to inspect the product and to make repairs or adjustments, as necessary, can result in injury to the rider or to others.
Maintenance Charging the Drive Battery: IMPORTANT! Before using the unit for the first time the battery needs to be charged for at least 8 to 12 hours - no more than 20 hours. Once battery is depleted, recharge for 8 to 12 hours - no more than 20 hours. IMPORTANT! Check the drive battery and charger (supply cord, connector) for wear and damage before charging. Do not charge the battery if damage has occurred.
Drive Battery Replacement NOTE: Batteries are installed, mounted and wired differently depending on model. Make a simple drawing on paper (or take pictures) how your battery is installed and how Red and Black wires are connected. NOTE: Remove seat screws and seat (varies depending on model). 1. 2. 3. Remove any clamps and Battery Covers. Disconnect wires. Carefully lift out the Battery. • Depending on the condition of the battery (i.e.: leakage) you may want to wear protective rubber gloves before removal.
Drive Motor Battery Maintenance Only an adult who has read and understands the safety warnings should handle, charge or recharge the battery. Failure to comply with all safety warnings may result in serious injury or death. Battery Fuse The drive motor circuit features a thermal fuse that will automatically trip and cut all power to the vehicle if the motor, electric system or battery is overloaded. The fuse will reset and power will be restored after a short time.
Troubleshooting Guide NOTE: Vehicle should be turned off and fully charged before doing troubleshooting. Problem Possible Cause Solution Vehicle does not run when switch is activated Battery wires not connected or are loose Connect battery wires according to assembly instructions, Check that the battery connectors are firmly plugged into each other. If wires are loose around the motor call Customer Service.
Troubleshooting Guide - continued Troubleshooting BEFORE YOU CALL SUPPORT: 1. 2. 3. 4. 5. 6. 7.
General: Part or model specifications are subject to change without notice. This Limited Warranty is the only warranty for the product. ALL WARRANTIES OTHER THAN STATED HEREIN ARE DISCLAIMED INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, TO THE EXTENT ALLOWABLE BY APPLICABLE LAW. ALL LIABILITY FOR INCIDENTAL, PUNITIVE, SPECIAL, OR CONSEQUENTIAL DAMAGES ARE EXPRESSLY DISCLAIMED, TO THE EXTENT ALLOWABLE BY APPLICABLE LAW.
[ USA ] PLEASE - BEFORE RETURNING TO STORE: Contact Huffy Customer Service. We are glad to assist you with any parts or assembly problems you might have! For Fast Customer Service and email: www.huffybikes.com/contact To Order Parts: www.huffybikes.com/parts OR TEL: 1 800 872 2453 (US) [ CANADA ] PLEASE - BEFORE RETURNING TO STORE: Contact Huffy Customer Service.
