Instructions / Assembly

Assembly

Seat Installation (various models)

Seat to Seat Post (Single Bolt Style): Some models are equipped

with a seat and seat post assembly that uses a single bolt and nut to

secure the seat to the seat post. The seat is assembled to the seat

post at the factory

Ensure the seat is secure to the seat post and the seat bolt is tight-

ened.

WARNING: To prevent the

seat coming loose and possible loss of

control, the “MIN-IN” (minimum inser-

tion) mark

on the Seat Post must

be below the top of the Seat Tube

SEAT AND SEAT POST SETUP:

1. If needed, loosen Nuts on Seat

Clamp

and rotate Seat into rid-

ing position.

2. Ensure the Seat Post

is fully

through the TOP Seat Clamp

3. Tighten the Seat Clamp so the Seat

does not move on the seat post.

4. If the Seat Clamp has a Nut on each side, tighten both nuts equally.

5. Point the Seat forward and put the Seat Post

into the Seat Tube

and proceed

to next step.

TIGHTEN THE QUICK RELEASE LEVER:

NOTE: The words “open” and “close” are on opposite sides of the quick release lever.

1. Move the Quick Release Lever

to the “open”

position so the word “open” is pointing away from

the Seat Post Clamp

CAUTION: Operate the Quick Release Lever

by hand only. Do not use a hammer or any other tool to

tighten the quick release lever.

2. You must use strong force to move the quick

release lever to the “close” position. If you can easily

move the lever to the “close” position, the clamping

force is too light.

g B

g A

g C