Instructions / Assembly

14
Assembly
Testing Seat Clamp and Post Clamp Tightness
To test the tightness of the seat clamp and the post clamp:
WARNING: Every time the quick release mechanism is loosened, make sure
the red re ector is correctly positioned.
• Try to turn the seat side-to-side and to move the front of the seat up and down.
• If the seat moves in the Seat Clamp:
• Loosen the Seat Clamp.
• Put the seat in the correct position and tighten the Seat Clamp tighter than before.
• Do this test again, until the seat does not move in the Seat Clamp.
• If the Seat Post moves in the Seat Tube:
• Move the Quick Release Lever to the “open” position.
• Put the seat in the correct position and tighten the Quick Release Lever tighter than
before.
• If necessary, loosen Quick Release Lever, tighten Adjusting Nut and re-tighten Quick
Release Lever.
• Do this test again, until the seat post does not move in the seat tube.
A
B
B
2
1
3
DUAL REAR REFLECTORS VARIOUS MODELS:
The Rear Re ectors
A
are may be pre-installed on
the bike chain stays. Make sure they are secure, not
bent and are pointing straight backwards.
Installation (as needed):
• Place Re ector
A
in position as shown and at-
tached with two supplied Screws
B
.
• Tighten securely. Do not over tighten.
Refl ector Installation (as equipped)
Re ector Installation:
1. Position FRONT Re ector
A
so it points
straight forward.
2. Tighten Clamp Screw.
3. Position Seat Post Re ector (if equipped)
B
so it points straight backwards.
4. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will damage
the Clamp.
B
A
DUAL REAR REFLECTORS VARIOUS MOD
ELS:
The Rear Re ectors
A
are may be pre-installed
on the bike chain stays. Make sure they are
secure, not bent and are pointing straight
backwards.
Installation (as needed):
• Place Re ector
A
in position as shown and
attached with two supplied Screws
B
.
• Tighten securely. Do not over tighten.
Refl ector Installation (as equipped)
Re ector Installation:
1. Position FRONT Re ector
A
so it points
straight forward.
2. Tighten Clamp Screw.
3. Position Seat Post Re ector (if equipped)
B
so it points straight backwards.
4. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will damage
the Clamp.
B
A
A
B
C
D
Fork Mounted Re ector Installation (if equipped)
1. With Fork pointing Forward, insert Bolt
A
through Re ector
B
and Fork Mounting
Hole
C
.
2. Install Washer and Locknut
D
.
3. Make sure Re ector
B
is pointing straight
forward and tighten Locknut securely.
A
B
B
2
1
3