Instructions / Assembly

15
Assembly
Re ector Installation (as equipped)
Re ector Installation:
1. Position FRONT Re ector
A
so it points
straight forward.
2. Tighten Clamp Screw.
3. Position Seat Post Re ector (if equipped)
B
so it points straight backwards.
4. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will damage
the Clamp.
B
A
Pedal Installation
CAUTION: There is a RIGHT pedal marked
R
and a
LEFT pedal marked
L
.
NOTE: A Pedal Wrench is preferred for attaching Pedals. A
thin open-end
wrench can also be used.
• The pedal marked
R
has right-hand threads. Tighten it
in a clockwise direction.
• The pedal marked
L
has left-hand threads. Tighten it in
a counterclockwise direction (anti-clockwise).
• Turn the right pedal marked
R
into the right side of the
crank arm, and the left pedal marked
L
into the left side
of the crank arm.
Tighten the pedals:
• Make sure the threads of each pedal are fully into the
crank arm.
WARNING: Ensure pedals are secure in crank
arms so they will not loosen. Periodically check tightness.
L
R
L R
DUAL REAR REFLECTORS VARIOUS MOD
ELS:
The Rear Re ectors
A
are may be pre-installed
on the bike chain stays. Make sure they are
secure, not bent and are pointing straight
backwards.
Installation (as needed):
• Place Re ector
A
in position as shown and
attached with two supplied Screws
B
.
• Tighten securely. Do not over tighten.
Refl ector Installation (as equipped)
Re ector Installation:
1. Position FRONT Re ector
A
so it points
straight forward.
2. Tighten Clamp Screw.
3. Position Seat Post Re ector (if equipped)
B
so it points straight backwards.
4. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will damage
the Clamp.
B
A
A
B
C
D
Fork Mounted Re ector Installation (if equipped)
1. With Fork pointing Forward, insert Bolt
A
through Re ector
B
and Fork Mounting
Hole
C
.
2. Install Washer and Locknut
D
.
3. Make sure Re ector
B
is pointing straight
forward and tighten Locknut securely.
A
B
B
2
1
3