Instructions / Assembly

9
Assembly
Installing the Front Wheel
C
B
A
C
A
E
B
D
WARNING:
• Do NOT use Axle Nuts
A
with-
out serrations to attach
the front wheel.
• Ensure wheel spins freely
without contacting fork
or fender.
• Failure to obey these
steps can allow the front
wheel to loosen while riding.
This can cause injury to the rider or to
others.
NOTE: See Brake Section to loosen and
Re-attach front Brakes (if equipped).
1. If the Axle Nuts and Washers are
already attached to the front wheel
axle, remove and set aside.
2. Set the wheel into the Front Fork
B
.
TABBED WHEEL RETAINERS
C
:
3. Install Wheel Retainers
C
making sure the tabs are in the fork
D
tab holes.
4. Install Axle Nuts
A
with serrated surface facing IN.
5. With the wheel in the center of the fork, tighten both Axle Nuts securely.
SHOULDER WASHERS
E
:
6. Place a Shoulder Washer
E
on each end of Axle with small shoulder facing IN as
shown.
7. Install Axle Nuts
A
with serrated surface facing IN.
8. With the wheel in the center of the fork, tighten both Axle Nuts securely.