Instructions / Assembly

20
Installing Derailleur Guard (on some models)
Dual Rear Re ectors (various models):
A
B
B
21
3
The Rear Re ectors
A
may
be pre-installed on the bike
chain stays. Make sure they are
secure, not bent and are pointing
straight backwards.
NOTE: Re ectors
A
either
attach with Screws
B
or are
SNAP on (see images).
1
BRACKET MOUNT: Attach
Bracket to Chain Stay securely
using Screws
B
.
2
SCREW MOUNT: Attach
Re ector to Bracket securely
using Screws
B
.
3
SNAP MOUNT: Slide Re ector DOWN onto Bracket until it SNAPS into place.
B
D
A
C
1. Remove Screws
A
from Frame Tabs
B
.
2. Install Guard
C
using two Screws
A
.
3. Make sure the Guard does not contact the
Derailleur
D
.
4. Tighten Screws
A
securely.
Re ector Installation (as equipped)
Re ector Installation:
1. Position FRONT Re ector
A
so it
points straight forward.
2. Tighten Clamp Screw.
3. Position Seat Post Re ector (if
equipped)
B
so it points straight
backwards.
4. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will
damage the Clamp.
B
A
Assembly