Instructions / Assembly

24
Brake System
Linear Pull Brake System - continued
Linear Pull Brake Pad Replacement
B
A
C
D
1. If necessary, loosen brake
cable Adjustment Bolt
A
.
2. Loosen and remove brake
pad Bolt/Screws
B
.
3. Remove old Brake Shoe
C
.
4. Install new Brake Shoe, mak-
ing sure it is pointing forward
and lined up evenly with the
Wheel Rim
D
.
5. Tighten brake pad Bolt/
Screw and Adjustment Bolt
according to Torque Chart.
WARNING: Replace Brake Pad with same model and type as original.
Test the tightness of the cable clamp ( g C):
1. Squeeze each Brake Levers
G
with  rm pressure.
2. Make sure the cable does not move in the Cable Clamp
E
.
3. If the cable moves in the cable clamp, adjust the brakes again but tighten the cable
clamp tighter than before.
4. Do this test again, until the cable does not move in the cable clamp.
Test the travel of each brake lever:
1. Squeeze each Brake Lever
G
with strong pressure
2. If the brake lever touches the grip, adjust the brakes again.
WARNING: After you adjust the brakes again, if either brake lever touches the grip
or does not work well, have a bicycle service shop repair or adjust the brakes.