User's Manual

4
1. Ensure your headset is turn ON, and audio gateway connected to phone correctly.
2. Place the headset on your ear in the desired wearing style.
3. Using the phone's keypad, dial the phone number.
4. To send the call, press the phone's SEND/CALL key the phone initiates the all.
5. The call will then transfer automatically to the headset when connection is made.
Ending a call from the headset
To end a call; when wearing the headset press the headset's Talk button.
Or you can end the call from the phone key pad.
Or when the other side hangs up the phone, the call ends automatically.
Receiving/Answering a call
If there is an incoming call while you are wearing the headset, a ring tone will sound in your headset and just
press the headset's Talk button to answer the call.
If you are not wearing the headset, then place the headset on your ear in the normal wearing position and use
the Talk button to accept the call.
If your cell phone supports auto answering a call, the headset will take the incoming call and you don't need to
press any button.
Speaker volume and volume control button
Headset offers adjust of speaker volume by press the volume up or down button. You can adjust the volume
to 15 pre-set levels.
Volume up and volume down button will regulate the volume to the speaker in these 15 steps. One step per
key press increases / decreases the desired volume until a satisfactory level is reached. An audible tone is
played for each step +/- and when either the minimum or maximum volume has been achieved.
Low battery warning
Headset:
The headset needs re-charging when the red LED is blinking once every 3 sec. You can also hear a special
tone of DO-LU-DO-LU-DO from the headset every 40 sec.
When you talk by the headset under battery low situation, the headset red LED is blinking 4 times every 3 sec.
Once the low battery warning indicator starts, you have around 10 minutes of talk time left and you will then
need to charge the battery in the headset.
Audio gateway:
The audio gateway needs re-charging when blue LED is flashing once every sec., while it's not in use.
Visual indicators
Headset state LED indication state
Power Off LED off
Standby mode Blue LED flash once every about 3 sec.
Charging in process Blue LED steady on
Charging completed LED off
Low power Standby: red LED flash once every 3 sec.
Talk: red LED flash 4 times every sec.
Pairing mode Blue LED and red LED cross flash.
Pairing successful Blue LED flash once every about 3 sec.
Active / on call Blue LED flash 4 times every 3 sec.
Audio Gateway state LED indication state
Charging in process LED steady on
Charging completed LED off
In coming call LED flash once every 4 sec.
a) If answer (active) LED flash twice every sec.
b) If not answer and LED 3 rapid flashes in 0.5 sec. then off phone disconnect